Home / Journal / Export packing

Crochet export packing: volumetric weight, carton fill and damage claims

Updated 8 November 2026 · Logistics, packaging and freight cost

Crochet export packing is the step where a light, bulky product meets a freight system that charges for space rather than for weight: the billable figure is the greater of actual weight and volumetric weight, so the carton’s outside dimensions — not the product inside — usually decide what the shipment costs.

Hand-crochet is close to the worst case for that arithmetic. A stuffed amigurumi or a bouquet is mostly air by volume, then it is packed into a carton with more air around it, and the whole thing travels as low-density cargo. Two orders of the same value can differ by a third in freight simply because one was packed into 60×40×40 cm and the other into 60×40×30. Below is the arithmetic, the packing trade-off that sits behind it, and what actually happens when a carton arrives crushed.

In this article

1. Billable weight, in three formulas · 2. Where crochet loses money · 3. Carton fill: the compression trade-off · 4. Board, stacking and humidity · 5. When a carton arrives damaged · 6. What carrier liability actually pays · 7. A packing spec you can copy

1. Billable weight, in three formulas

Every mode converts volume into a chargeable mass, then charges whichever is higher — actual gross weight or the converted figure. The divisor differs by mode, and that single number changes the answer more than most buyers expect.

ModeConversion1 cubic metre becomes
Air freight (general cargo, IATA basis)L × W × H in cm ÷ 6,000about 167 kg
Express courier (commonly DHL / UPS / FedEx)L × W × H in cm ÷ 5,000about 200 kg
Ocean LCLW/M — revenue ton, 1 CBM or 1,000 kg, whichever is greater1,000 kg

Work one carton through both air divisors. A carton of 60 × 40 × 40 cm is 96,000 cm³: divided by 6,000 it bills as 16 kg, divided by 5,000 it bills as 19.2 kg. If the carton actually weighs 6 kg, the shipment pays for 10 to 13 kg of air it never had. Now shorten the same carton to 30 cm high: 72,000 cm³ bills as 12 kg by air and 14.4 kg by express. Ten centimetres of empty headspace, four kilos of freight — that is the whole argument for measuring before quoting.

Two measurement rules that decide disputes later: measure the outside of the carton, including any bulge; and for palletised freight measure the pallet footprint and total height, because the pallet void counts. A carton that bulges 2 cm on one side is a different billable weight from the one on your drawing.

Three practical consequences follow. First, quote freight per carton rather than per piece, since the piece weight is almost irrelevant. Second, ask the forwarder which divisor applies to the specific service — a routing that moves from airport cargo to a courier network can change the divisor mid-journey. Third, treat the carton as a design object with fixed dimensions, not as whatever box is in stock that day, because a stable carton size is what makes a landed-cost estimate repeatable.

2. Where crochet loses money

The density of packed crochet is low and fairly predictable, which is useful: it means the packing plan, not the product, controls the freight line. Three patterns account for most of the waste we see in incoming cartons.

Headspace above the top layer

Pieces are stacked until the carton is nearly full, then the flaps are closed. Whatever gap remains is pure billable volume with no product in it. A 10 cm gap on a 40 cm carton is a quarter of the height.

Single-piece cartons for assorted orders

Mixed orders often get one box per SKU because that is how the picking list reads. Consolidating into fewer, fuller cartons reduces both void volume and the number of packages — and package count matters twice, because ocean and air liability limits are calculated per package as well as per kilo.

Retail packaging inside transit packaging

If the piece ships in a printed retail box, the transit carton must fit the retail box, not the piece. That is legitimate, but it should be a decision with a number attached: model the retail box as solid volume and price the freight on it, rather than discovering the difference on the invoice.

3. Carton fill: the compression trade-off

The instinct after reading the arithmetic is to compress everything. Crochet resists that instinct in a specific way: the stitch is a three-dimensional structure, and compressing it does not flatten it evenly — it creases at the fold lines and recovers unevenly. A toy that spends three weeks under compression in a humid container can come out with a permanently flattened face, and no amount of steaming restores the original roundness.

Fill conditionWhat happens in transitCost of getting it wrong
Under-filledWalls collapse inward under stacking load; the carton loses its own strengthCrushed pieces, and a carton that no longer stacks
Correctly filledContents share the load with the board; the carton behaves as designed—
Over-filledFlaps bow; the bulge adds billable volume and stress on the score linesHigher freight, deformed stitches, cartons that will not palletise

The workable compromise for soft crochet is a light inner bag — a poly bag with a controlled amount of air, sealed flat rather than vacuumed hard — plus a fill that closes the top gap without pressing the top layer. Vacuum compression is appropriate for some textile categories and is a poor fit for structured crochet: it saves volume and costs shape. If a buyer asks for vacuum packing to cut freight, the honest answer is to test one carton first and inspect the pieces after a week, not to promise a percentage.

The filling inside the piece behaves differently from the shell. A fibre fill that is compressed for a long voyage loses loft and takes time to recover, which is why press-packing and stuffing choice have to be decided together rather than one after the other; we cover the material side in crochet toy filling materials.

There is also a regulatory layer that now touches void space directly. Under the EU Packaging and Packaging Reusable Waste Regulation, the obligation to minimise packaging starts on 12 August 2026, while the specific ceiling on empty space — a maximum void ratio of 50% for e-commerce packaging — applies from 1 January 2030. The two dates are frequently quoted as one; they are separate obligations, and the earlier one is about being able to demonstrate why each layer of packaging is necessary, not about hitting a percentage.

4. Board, stacking and humidity

Carton strength is usually quoted as either a burst figure (Mullen) or an edge crush figure (ECT). For a stacked container load, ECT is the more relevant number, because cartons in a container fail by the vertical walls buckling rather than by the face puncturing.

Two factors erode the calculated strength in practice. Time under load is one: corrugated board creeps, so a carton rated for a stack height for a short period will sag over a long sea voyage. Moisture is the other, and it is the bigger one — board that has absorbed humidity loses a large part of its stacking strength, which is why a container that spends three weeks crossing a warm ocean is a harder environment than the same carton tested in a dry warehouse.

So the practical instructions are unglamorous: single-wall board for light, low-stack shipments; double-wall where the stack is high or the voyage long; a moisture barrier for humid routes; and a stacking plan that respects what the board can hold at the humidity it will meet, not at the humidity of the sample room. If a buyer needs distribution testing rather than a board certificate, the usual protocols are ISTA 1A for a non-simulation integrity check and ISTA 3A for a parcel-delivery simulation — worth specifying by name so both sides are discussing the same test.

5. When a carton arrives damaged

Damage claims are won or lost in the first hour after delivery, and almost entirely on paperwork that was created before the container was loaded. The reason is procedural rather than legal: carrier liability only pays up to a statutory cap, so the recovery almost always comes from cargo insurance, and an insurer will ask for evidence that the shipper could not have produced retrospectively.

Do thisBecause
Note the damage on the delivery receipt before signing, or sign “subject to inspection”A clean signature is treated as prima facie evidence of good delivery; reversing it later is expensive
Photograph the carton as found, then the opened carton, then the damaged piecesInsurers assess cause from the packaging, not only the product
Keep cartons, fill material and pallets until the claim closesSurveyors may want to inspect the actual board
Record carton count, seal number, container number and the tally sheetEstablishes whether the loss happened before or after handover
Give written notice within the treaty window, not afterLate notice can extinguish an otherwise valid claim

The windows are short and they differ by mode. Under the Hague-Visby regime for sea carriage, notice of non-apparent loss or damage must be given within three days of delivery, and legal proceedings must start within one year. Under the Montreal Convention for air carriage, a complaint must be made within 14 days of receipt for damage and 21 days for delay, with a two-year limitation period. Neither window waits for the internal conversation about who is responsible.

6. What carrier liability actually pays

This is the part that surprises buyers most. Both conventions cap the carrier’s liability at a figure that is almost always below the commercial value of hand-made goods.

ModeStatutory capWhat it means in practice
Sea (Hague-Visby)666.67 SDR per package or 2 SDR per kg of gross weight, whichever is higherA 10 kg carton recovers about 20 SDR, not the value of what was inside
Air (Montreal Convention)22 SDR per kg, in force since 28 December 2019Priced by weight, so a light bulky carton recovers very little

Two conclusions follow, and they are the reason this section belongs in a packing article rather than a legal one. First, declare value or insure: the cap applies unless a higher value was declared before carriage and inserted in the transport document. Second, weight is the recovery base, which puts crochet at a structural disadvantage — the same shipment can be expensive to replace and cheap to compensate, because it is bulky and light. For a mixed order, that argues for insuring the consignment rather than relying on the carrier.

The cap is a ceiling on the carrier’s liability, not a statement of what your goods are worth. Cargo insurance is a separate contract, and it is the instrument that actually closes the gap.

7. A packing spec you can copy

The useful output of all of the above is a one-page packing specification agreed before production, so that the carton is a controlled variable rather than a surprise. Ours carries these fields, and any supplier’s can:

Once those seven fields are fixed, the freight estimate stops being an opinion. You can compute billable weight before booking, compare two packing options on landed cost, and — if a carton does arrive crushed — show exactly which specification was breached. That is a stronger position than any argument conducted after the fact.

Why is my crochet shipment charged on volume instead of weight?

Because the freight system charges for the space a shipment occupies as well as for its mass, and it does so by converting volume into an equivalent weight and then billing whichever figure is higher. Air freight divides the carton volume in cubic centimetres by 6,000, so one cubic metre bills as roughly 167 kg; most express couriers divide by 5,000, so the same cubic metre bills as 200 kg. Packed crochet is light for its size, so the volumetric figure almost always wins. The charge is not a penalty, it is the same rule applied to every low-density cargo.

Does compressing the carton actually reduce freight enough to be worth it?

It can, and the arithmetic is easy to check before deciding. Removing 10 cm from the height of a 60 × 40 × 40 cm carton cuts 24,000 cm³, which is 4 kg of billable air freight on the 6,000 divisor. Whether that is worth doing depends on what compression does to the product: structured crochet creases at fold lines and recovers unevenly, so a shape-critical item should not be hard-compressed for a long voyage. The honest approach is to test one carton, inspect after a week, and then decide — rather than assuming a percentage saving.

What is the difference between ECT and Mullen, and which should I ask for?

ECT (edge crush test) measures the force a corrugated wall resists when compressed along its edge; Mullen (burst) measures the pressure a board face resists before puncturing. For a container load where cartons are stacked, ECT is the more relevant figure, because the failure mode is the vertical walls buckling, not the face being punctured. Ask for the grade and the test method by name, and ask at what humidity the figure was measured, since absorbed moisture removes a large part of the strength.

Who pays when a carton arrives crushed?

The carrier pays only up to a statutory cap, which for sea carriage under the Hague-Visby regime is 666.67 SDR per package or 2 SDR per kilogram of gross weight, whichever is higher; for air carriage under the Montreal Convention it is 22 SDR per kilogram. Both are usually well below the commercial value of hand-made goods, and crochet is doubly exposed because it is light, so the per-kilogram formula recovers little. The remainder comes from cargo insurance, which is why the evidence pack — photographs, the noted delivery receipt, carton count and seal number — matters more than the argument that follows.

How long do we have to file a claim?

Shorter than most people assume. For sea carriage, notice of non-apparent damage must be given in writing within three days of delivery, and proceedings must begin within one year. For air carriage, a complaint must be made within 14 days of receipt for damage and 21 days for delay, with a two-year limitation period. Apparent damage should be noted on the delivery receipt at the moment of handover. None of these windows pause while the responsibility question is being discussed internally.

Is vacuum packing a good idea for crochet?

It depends on the construction. Vacuum compression removes air and volume efficiently, but a compressed three-dimensional stitch takes a set at the fold lines, and pieces that ship for weeks under vacuum can arrive permanently flattened. For flat-knit panels and some home textiles it is workable; for stuffed toys and shaped flowers it is usually the wrong trade. A controlled-air poly bag, sealed flat rather than vacuumed hard, keeps most of the volume benefit without crushing the structure.

Does the EU packaging rules change my void fill?

Two obligations are involved and they have different dates. The duty to minimise packaging, and to be able to justify each layer, applies from 12 August 2026. The specific empty-space ceiling — a maximum void ratio of 50% for e-commerce packaging — applies from 1 January 2030. The 2026 obligation is about evidence and design rationale rather than a percentage, which is precisely why a written packing specification with photographs is worth having now rather than in 2029.

Related: carton shipping marks and numbering — the four fields, the denominator that has to be closed after the count, and the version code that decides whether a carton is accepted at goods-in.

Want the packing arithmetic run on your own carton? Send the carton dimensions, pieces per carton and destination, and we will return the billable weight under both divisors, the pallet plan, and the packing specification we would use — before you commit to a quantity.

Email bianhaitao@kivastitch.com · WhatsApp +44 7796 847136 · See DDP shipping and spec-to-bulk tolerance.